Delphi — Install Rocker Arm Assembly

Cylinder Head and Valves Remove socket from cap screw and rotate socket counterclockwise (viewed from rear of engine) one flat and reinstall on cap screw. Marks should now be 60 ° apart. Tighten cap screws (clockwise) until marks on socket (A) and shaft clamp [or spacers (C) at each end location] are aligned. 02 020 64 RG9201A –UN–30JUL99 NOTE: If cap screw is tightened beyond aligning mark, loosen cap screw and repeat procedure starting with initial torque of 30 (22 lb-ft). 2. Repeat procedure on remaining cap screws and torque-turn cap screws to the following specifications.

Torque-Turn Clamp Cap Screws Specification Rocker Arm Shaft Hold-Down Clamp Cap Screws (Dual Rail Fuel System)—Final Torque-Turn 60 ° ± 5 ° ................................................. IMPORTANT: Position electronic unit injector wiring harness so that wires DO NOT touch rocker arms. RG9203A –UN–30JUL99 3. Install unit injector wiring harness. Apply LOCTITE 222 (TY24311) Thread Lock and Sealer (Low Strength) to harness cap screws. Tighten cap screws to specifications below. Torque-Turn Clamp Cap Screws A—Line on Socket B—Line on Shaft Clamp C—Line on Spacer Specification Unit Injector Wiring Harness Bracket-to-Rear of Head—Torque 25 (18 lb-ft) ..................................

Unit Injector Wiring Harness Solenoid Wire Retaining Nut 1 Torque 3.0 (27 lb-in.) ........................................................................... Unit Injector Harness Clips-to-Rocker Arm Shaft Clamps—Torque 35 (26 lb-ft) .............................................................. 4. Adjust valve-to-bridge clearance and injector preload. (See CHECK AND ADJUST VALVE ASSEMBLY CLEARANCES AND INJECTOR PRELOAD, earlier in this group.) LOCTITE is a registered trademark of Loctite Corp. 1 Apply LOCTITE 222 (TY24311) Thread Lock and Sealer (Low Strength) to nut only.

CTM100 (06APR04) 02-020-64 P OWER T ECH 10.5 L & 12.5 L Diesel Engines Continued on next page RG,RG34710,97 –19–01NOV00–5/9 040604 PN=136