Cylinder Block, Liners, Pistons, and Rods Complete Disassembly of Cylinder Block (If Required) If complete inspection and “Hot Tank” cleaning of cylinder block is required, refer to the appropriate group for removal of all external and internal mounted components listed below: 02 030 38 1. Remove crankshaft and pulley if not previously removed. (See REMOVE CRANKSHAFT in Group 040.) 2. Remove coolant pump and all remaining cooling system components. (See REMOVE COOLANT PUMP in Group 070.) 3. Remove timing gear cover. (See REMOVE TIMING GEAR COVER in Group 040.). Remove front plate. (See REMOVE AND INSTALL CYLINDER BLOCK FRONT PLATE earlier in this group.) 4.
Remove engine oil pump and all remaining lubrication system components. (See REMOVE ENGINE OIL PUMP in Group 060.) 5. Remove all components (water gallery plugs, oil gallery plugs, bushings, and engine serial number plate) before inspecting and cleaning cylinder block. Use JDG782 Oil Gallery Plug Tool to remove and install gallery plugs. RG,RG34710,126 –19–02AUG99–1/1 CTM100 (06APR04) 02-030-38 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=178