Delphi — Inspect and Clean Cylinder Block

CTM100 (06APR04) 02-030-39 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=179 Cylinder Block, Liners, Pistons, and Rods Inspect and Clean Cylinder Block NOTE: All components, water gallery plugs, and oil gallery plugs must be removed from the cylinder block for inspection and cleaning. Refer to the proper group for removal of all external and internal mounted components. –UN–21MAY98 1. Use D17015BR O-Ring Groove Cleaning Brush or an equivalent brush to thoroughly clean all debris from cylinder liner O-ring bores. RG8210 2. Remove cylinder head locating dowels, if not Cleaning Head Bolt Threads in Block previously removed.

Clean out all threaded holes for cylinder head mounting cap screws in top deck of cylinder block. Use JDG978 Tap or an equivalent M16 x 2.0 tap approximately 152.4 mm (6.0 in.) long. Use compressed air to remove any debris or fluid which may be present in the cap screw hole. IMPORTANT: If cylinder block is cleaned in a hot tank, be sure to remove any aluminum parts. Aluminum parts can be damaged or destroyed by hot tank solutions. Remove all serial number plates. 3. Clean block thoroughly using cleaning solvent, pressure steam, or a hot tank. Continued on next page RG,RG34710,127 –19–09SEP99–1/2 02 030 39