CTM100 (06APR04) 02-030-41 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=181 Cylinder Block, Liners, Pistons, and Rods Measure Cylinder Block Refer to the appropriate groups for a more detailed description of the features being measured. Compare measurements with specifications given below. 1. Assemble and measure main and thrust bearing bores. –UN–21MAY98 Compare measurements with specifications given below: Specification RG8208 Main and Thrust Bearings— Assembled ID Without Bearings........................... 133.097—133.123 mm Measuring Block Top Deck Flatness (5.2400—5.2410 in.) Main Bearing Surface Width.................
37.77—38.03 mm (1.487—1.497 in.) Thrust Bearing Surface Width (No. 5 Main).......................................... 37.51—38.29 mm (1.476—1.507 in.) Overall Thrust Bearing Cap Width........ 43.25—43.75 mm (1.703—1.722 in.) If any main or thrust bearing cap assembled ID is not within specification, blank (generic) bearing caps are available and must be line bored to specification by a qualified machine shop. (See MEASURE ASSEMBLED ID OF MAIN BEARING CAPS in Group 040.) 2. Measure cylinder block top deck flatness using D05012ST Precision Straightedge and feeler gauge. Resurface as required.
Specification Cylinder Block Top Deck Surface Finish—Surface Finish (Surface Mill Only)................................................... 3.2 micrometers (125 micro-in.) Max. Wave Height........................................... 0.008 micrometers (0.0002 micro-in.) Max. Wave Depth....................................... 2.0 micrometers (79 micro-in.) Main Bearing Bore Centerline-to-Top Deck— Minimum Distance..................................................... 429.92—430.07 mm (16.926—16.932 in.) Continued on next page RG,RG34710,128 –19–03AUG99–1/2 02 030 41