Delphi — Recheck Cylinder Liner Standout (Height Above Block)

CTM100 (06APR04) 02-030-43 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=183 Cylinder Block, Liners, Pistons, and Rods Recheck Cylinder Liner Standout (Height Above Block) NOTE: If a new liner assembly is being installed in a new or used cylinder block, liner standout must be checked. –UN–05DEC97 Be sure liner bore in cylinder block (B) and top deck of cylinder block are clean. RG7142 1. Install liners without O-rings and square packing. Secure with cap screws and washers, as outlined Liner Counterbore Depth earlier in this group. (See REMOVE PISTONS AND CONNECTING RODS in this group.) NOTE: Install liner with the identifying mark toward the front of the engine.

Rotate 90° if pits or erosion exceed limits outlined during liner inspection. 2. Measure liner standout. (See MEASURE CYLINDER –UN–21MAY98 LINER STANDOUT earlier in this group.) Specification Cylinder Liner Standout—Height RG8329 Above Block.................................................................. 0.030—0.117 mm (0.0012—0.0046 in.) Measuring Liner Standout If liner standout is above specification, recheck liner A—Liner Flange Counterbore Depth support flange (C) for possible remaining burrs or B—Block incorrect counterbore depth (A) in block. If burrs are C—Liner Support Flange present, use respective liner and lapping compound to remove burr.

Completely clean cylinder liner bore after lapping. IMPORTANT: ONE LINER SHIM ONLY may be installed under any given liner flange. If liner standout is below specifications, remove liner and install shim as needed to bring liner standout to within specification. Specification Cylinder Liner Shims Available— Thickness.................................................................... 0.05 mm (0.002 in.) Thickness.................................................................... 0.10 mm (0.004 in.) RG,RG34710,129 –19–30SEP97–1/1 02 030 43