Delphi — Remove, Clean, and Inspect Engine Oil Cooler

CTM100 (06APR04) 02-060-7 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=275 Lubrication System 4. Remove two large hex nuts (D) securing oil cooler (C) to housing (A) and remove cooler from housing. Remove and discard gasket (B) and O-rings (E). 5. Clean all parts and flush oil cooler with solvent. Dry with compressed air. 6. Thoroughly inspect oil cooler for plugging, damage, or leaks. NOTE: If mixing of oil and coolant is suspected, pressure test oil cooler in liquid and compressed air. Use specified air pressure for testing. Replace oil –UN–10DEC97 cooler as necessary. Specification Oil Cooler—Test Pressure...........................

140—170 kPa (1.4—1.7 bar) RG8771 (20—25 psi) Oil Cooler and Housing Assembly IMPORTANT: When installing oil cooler into housing, ensure that face of both mounting nuts A—Oil Cooler Housing is square to threads for proper torque. B—Gasket C—Oil Cooler D—Nut (2 Used) 7. Apply TY9473 LOCTITE 242 Thread Lock and Sealer E—O-Ring (2 Used) to oil cooler hex nuts. 8. Install oil cooler in housing using a new gasket and two new O-rings. Tighten two large hex nuts to specifications. Specification Oil Cooler-to-Housing Nuts— Torque............................................................................. 50 N•m (37 lb-ft) 9.

If removed, install oil cooler drain cock handle and tighten to specifications. Specification Oil Cooler Drain Cock Handle— Torque.............................................................................. 3 N•m (25 lb-in.) 10. If removed, install oil cooler housing expansion plug and tighten to specified depth. Specification Oil Cooler Expansion Plug— Installed Depth................................................ Flush to 1.5 mm (0.059 in.) Below Surface LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,212 –19–12AUG99–2/3 02 060 7