Cooling System Checking Upper Tensioner Spring Tension A belt tension gauge will not give an accurate measure of the belt tension when automatic spring tensioner is used. Measure tensioner spring tension using a torque wrench and procedure outlined below: 02 070 6 1. Release tension on belt using a long handle 1/2-in. breaker bar in tension arm. Remove belt from pulleys. RG8727 –UN–10DEC97 2. Release tension on tension arm and remove breaker bar. Marking Upper Belt Tensioner 3. Put a mark (A) on swing arm of tensioner as shown. 4. Measure 21 mm (0.83 in.) from first mark (A) and put a second mark (B) on tensioner mounting base. 5.
Rotate the swing arm using a torque wrench until marks (A and B) are aligned. RG8726 –UN–10DEC97 6. Record torque wrench measurement and compare with specification below. Replace tensioner assembly as required. Specification Belt Tensioner Upper Spring— Tension 18—23 (13—17 lb-ft) ............................................................. Testing Upper Tensioner A—Mark on Swing Arm B—Mark on Tensioner Base RG,RG34710,225 –19–30SEP97–2/2 CTM100 (06APR04) 02-070-6 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=290