Delphi — Replace Belt Tensioner Assembly

CTM100 (06APR04) 02-070-7 P OWER T ECH 10.5 L & 12.5 L Diesel Engines 040604 PN=291 Cooling System Replace Belt Tensioner Assembly Follow same procedure for replacement of upper (A) and lower (C) belt tensioner. 1. Release tension on pulley and remove belt. 2. Check spring tension on tensioner. (See INSPECT AND CHECK BELT TENSIONER SPRING TENSION earlier in this group.) NOTE: Later cam access covers will have two locator holes for positioning of the upper belt tensioner. Mark location of hole being used for ease of installation. 3. Remove cap screw and remove the tensioner assembly. NOTE:

If cam access cover is equipped with two upper tensioner locating holes, reinstall upper tensioner using locating hole previously marked on disassembly. Apply LOCTITE 242 Thread Lock and Sealer (TY9473) to tensioner shoulder bolt or cap screw before installing. –UN–30JUL99 4. Install tensioner using locator in upper tensioner only and tighten shoulder bolt or flanged head cap screw to specifications. RG10270 Specification Belt Tensioner Shoulder Bolt or Upper and Lower Belt Tensioners Flanged Head Cap Screw— Torque............................................................................. 50 N•m (37 lb-ft) A—Upper Belt Tensioner B—Belt Idler Pulley Assembly NOTE:

Apply LOCTITE 242 Thread Lock and Sealer C—Lower Belt Tensioner D—Lower Tensioner Bracket (TY9473) to idler pulley mounting cap screw before installing. 5. Install idler pulley assembly. 6. Tighten idler pulley (B) cap screw to specifications. Specification Fan Belt Idler Pulley—Torque......................................... 68 N•m (50 lb-ft) LOCTITE is a registered trademark of Loctite Corp. Continued on next page RG,RG34710,226 –19–18SEP02–1/2 02 070 7