John Deere 450DLC — Main Controller (MCF) Circuit Theory of Operation

TM2361 (24JUN08) 9015-15-26 450DLC Excavator Operation and Tests 062608 PN=470 Sub-System Diagnostics The MCF determines which pump has the greater load pump control solenoid (pump with the high delivery by comparing signals from the delivery pressure pressure) to decrease pump flow rate to minimum. sensors (B35 and B37). The pump with the higher delivery pressure indicates the pump with the greater The MCF will cancel relief flow rate reducing control if load. the right or left travel pressure sensors (B56 or B57) detect travel pilot pressure or the swing pressure The MCF compares the actual pump displacement sensor (B33) detects swing pilot pressure.

with the calculated maximum target pump displacement, then sends a signal to the pump control Swing Horsepower Reducing Control: To provide solenoid (Y12 or Y13) of the pump having the higher better control during swing operation, the delivery flow delivery pressure to decrease the flow rate of that rate of pump 1 increases and the delivery flow rate of pump, thus reducing pump load. pump 2 (which includes swing function) decreases. Relief Flow Reducing Control: Controls hydraulic MCF inputs involved: energy loss and prevents hydraulic oil temperature from rising due to pressure variations caused by • Swing pressure sensor (B33) changing loads.

• Pump 1 delivery pressure sensor (B35) • Pump 1 control pressure sensor (B36) MCF inputs involved: • Pump 2 delivery pressure sensor (B37) • Pump 2 control pressure sensor (B38) • Swing pressure sensor (B33) 9015 15 26 • Pump 1 delivery pressure sensor (B35) MCF outputs involved: • Pump 1 control pressure sensor (B36) • Pump 2 delivery pressure sensor (B37) • Pump 1 control solenoid (Y12) • Pump 2 control pressure sensor (B38) • Pump 2 control solenoid (Y13) • Travel right pressure sensor (B56) • Travel left pressure sensor (B57) The MCF determines the actual swash plate angle from signals received from pump control pressure MCF outputs involved:

sensors (B36 and B38) (terminals D11 and D4). The MCF determines the target swash plate angle from • Pump 1 control solenoid (Y12) signals received from pump delivery pressure sensors • Pump 2 control solenoid (Y13) (B35 and B37) (terminals C3 and C12). The MCF determines the actual pump displacement The MCF continually compares signals from the pump (swash plate angle) from signals received from pump control pressure sensors to signals from the pump control pressure sensors (B36 and B38) (terminals delivery pressure sensors. D11 and D4).

The MCF determines the target pump displacement (swash plate angle) from signals When the swing function is operated, swing pressure received from pump delivery pressure sensors (B35 sensor (B33) detects swing pilot pressure and sends a and B37) (terminals C3 and C12). corresponding signal to terminal D16 on the MCF. The MCF continually compares signals from the pump The MCF compares the actual swash plate angle with control pressure sensors to signals from the pump the target swash plate angle, then sends the delivery pressure sensors. appropriate amount of current to pump control solenoids (Y12 and Y13) to compensate for the When pump delivery pressure reaches 30 900 kPa difference.

(309 bar) (4482 psi), the MCF sends a signal to the Continued on next page CS33148,00008EB –19–28APR06–9/15