TM2361 (24JUN08) 9025-25-47 450DLC Excavator Operation and Tests 062608 PN=907 Tests 3. Disconnect wiring harness at pump 1 (4-Spool) control 7 7 solenoid (3) and pump 2 (5-Spool) control solenoid (4). 3 4. Raise right track off the ground for pump 1 or left track 4 for pump 2. 15 5. Run machine at specifications. Specification 28 5 –UN–23MAR06 Engine—Speed............................................................................ Fast Idle Work Mode Switch—Position...................................................... Dig Mode Power Mode Switch—Position.......................................................
P Mode Auto Idle Switch—Position.................................................................... Off Boom Mode Switch—Position............................................................... Off 5 TX1004087 Travel Speed Switch—Position.............................................. Slow (Turtle) 16 27 6. Actuate the travel function to full speed. Record the Pump Servo Piston Minimum and Maximum Adjusting Screws cycle time for one revolution. 9 6 5 7 Specification 8 Pump Servo Piston Minimum Flow—Cycle Time.................................... 48—52 sec. at slow speed with track raised for one revolution from a running start 7.
Adjust servo piston minimum flow adjusting screw (5) for pump 1 (15) and pump 2 (16) as needed. –UN–23MAR06 Loosen nut (6). Turn adjusting screw in to decrease the cycle time by increasing pump flow; turn adjusting screw out to increase the cycle time by decreasing TX1004088 pump flow. Specification Pump Servo Piston Minimum Flow Adjusting Screw Pump Servo Piston Minimum Flow—Cycle Time Change...................... 4 sec. approximate per 1/4 turn Pump 1 Servo Piston Minimum 3—Pump 1 (4-Spool) Control Solenoid Flow Using a Flow Meter—Flow 4—Pump 2 (5-Spool) Control Solenoid Rate Change..............................................
6.9 L/min approximate per 1/4 5—Servo Piston Minimum Flow Adjusting Screw turn 6—Nut 1.79 gpm approximate per 1/4 7—Servo Piston Maximum Flow Adjusting Screw turn 8—Nut Pump 2 Servo Piston Minimum 9—Servo Piston Flow Using a Flow Meter—Flow 15—Pump 1 Rate Change.............................................. 6.7 L/min approximate per 1/4 16—Pump 2 turn 27—Pilot Pump 1.77 gpm approximate per 1/4 28—Fan Drive Pump turn NOTE: The flow rate change for pump 1 is greater because pump 1 turns at 1.03 times engine speed. OUT3035,0000037 –19–19APR06–2/2 9025 25 47