John Deere 450DLC — Cylinder Drift Test—Arm, Boom, and Bucket

Tests 1. Heat hydraulic oil to specification. Perform Hydraulic Oil Warm-Up Procedure. (Group 9025-25.) Specification Hydraulic Oil—Temperature 45—55 ° C ........................................................ 110—130 ° F 2. Fill bucket with specified load. Specification Bucket Load—Weight 2850 kg approximate ............................................... 6280 lb approximate 3. Position machine as shown with bucket cylinder fully extended and arm cylinder fully retracted. 4. Turn engine off 5. Measure movement of boom, arm and bucket cylinders after 5 minutes. Specification Test—Time 5 minutes .................................................................................

TX04577,00000F8 –19–15MAY08–2/3 TM2361 (24JUN08) 9025-25-68 450DLC Excavator Operation and Tests 062608 PN=928 6. Compare measurement with specification. Cylinder Drift Test—Arm, Boom, and Bucket—Specification Boom Cylinder—Drift...................................................... 15 mm maximum 0.6 in. maximum Arm Cylinder—Drift......................................................... 20 mm maximum 08 in. maximum –UN–26APR01 Bucket Cylinder—Drift.................................................... 20 mm maximum 0.8 in. maximum Bucket Bottom to Ground—Drift.................................................... 100 mm 2 3.9 in.

T141254 2—100 mm (3.9 in.) Cylinder Drift Test Position TX04577,00000F8 –19–15MAY08–3/3 9025 25 68