. OPERATION EXPLANATION OF COMPONENTS Max. speed [km/h (MPH)] 18.1 (11.2) 7.6 (4.7) 58.6 (36.4) 38.4 (23.9) 25.5 (15.8) 16.2 (10.1) 10.7 (6.6) 6.8 (4.2) Always place the gear shift lever securely in position when operating it. If the gear shift lever is not placed securely in position, the shift lever position pilot lamp display on the machine monitor may go out and the transmission system caution lamp may light up. Before shifting between forward and reverse, stop the machine completely and then run the engine at low idle. When starting the engine, if the gear shift lever is not at the N (neutral) position, the engine will not start.
When the starting switch is turned from the OFF position to the ON position, if the gear shift lever is not at the N (neutral) position, the shift lever position pilot lamp flashes, the central warning lamp lights up, and the alarm buzzer sounds. When this happens, if the gear shift lever is returned to the N (neutral) position, the lamps will go out and the buzzer will stop. When the parking brake is applied, if the gear shift lever is not at the N (Neutral) position, the central warning lamp will light up and the alarm buzzer will sound.
If the gear shift lever is set to any position other than N (neutral) when the dump lever is at a position other than FLOAT or the dump body is still raised, the central warning lamp will light up and the alarm buzzer will sound. The gear shift lever must not be returned to the N (neutral) position while traveling. Release the accelerator pedal and run the engine at low idle when moving the shift lever from the N position to the forward or reverse position.
3 - 42 Positions 5 - Use t hese positions when t raveling on soft groun d or places where i t is difficul t to trave l at high speed, when starting uphill with the machine loaded, or when traveling downhill when i t is necessary to use the braking force of the engine. While the du mp body i s raised, the transmissio n is fixed to the 1st gear and is not changed. Keep the dump body lowered d urin REMARK If the machin e is driven when th e dump body is n ot completely lowered, if the gea r shift lever is at a position b etween 5 and 1, the speed range is xed at 1st shifted . ( This conforms to E safety standard (EN474-6 5.1.3).
Th e autom atic gear shifting r ange f or each p osition is as shown below. Position Speed range R2 R2nd torque converter - direct R1 R1st torque converter - direct D 2nd torque converter - 6th direct 5 1st torque converter - 5th direct 4 1st torque converter - 4th direct 3 1st torque converter - 3rd direct 2 1st torque converter - 2nd direct 1 1st torque converter - 1st direct