OPERATING THE MACHINE ATTACHMENT PEDAL (ACCELERATOR TYPE) This pedal has been exclusively designed to operate a breaker so that the pedal can be tilted forward only. 1. Select “BREAKER” on monitor work mode screen (3). Refer to “Work mode” on page 5-11 for work mode-set opera- tion. 3 2. Check that bolt (4) is contact with cover (5) when attach- ment pedal (accelerator type) (1) is locked. WARNING: Unless bolt (4) is not in contact with cover (5), attachment pedal (accelerator type) (1) may fall back, causing hydraulic oil to flow in reverse. Failure of the breaker may result. 3. Tilt pedal lock (2) forward to unlock the pedal. 4.
Press attachment pedal (accelerator type) (1) forward to operate the breaker. T1V5-05-01-109 5. When attachment pedal (accelerator type) (1) is released, the breaker stops operation. 2 1 6 6. When not required to operate attachment pedal (accel- erator type) (1), place pedal lock (2) in the LOCK position. NOTE: The positioning angle of attachment pedal (accelerator type) (1) is possible to adjust as needed by loosening bolts (6) (3 used). After adjustment is complete, tighten bolts (6) (3 used). 4 5 Attachment pedal (accelerator type) in the UNLOCK position M1J1-13-004 1 6 2 4 5 Attachment pedal (accelerator type) in the LOCK position M1J1-13-005 5-4