TROUBLESHOOTING H-7 H-7 Speed or power of boom is low 20-510 PC130-7 (1) Trouble • Speed or power of boom is low. Related information • Carry out the troubleshooting in working mode A. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of right PPC valve (boom circuit) aPrepare with engine stopped, then run engine at high idling and carry out troubleshooting.
Right work equipment control lever PPC valve output pressure Neutral position 0 MPa {0 kg/cm2} Boom RAISE position Boom LOWER position 2.84 – 3.43 MPa {29 – 35 kg/cm2} 2 Malfunction of boom con- trol valve (spool) The spool of the boom control valve may have a malfunction. Check it directly. 3 Malfunction of boom con- trol valve (pressure com- pensation valve) The pressure compensation valve of the boom control valve may have a malfunction. Check it directly. 4 Malfunction of boom con- trol valve (regeneration valve) The regeneration valve of the boom control valve may have a malfunc- tion or a defective seal. Check it directly.
5 Malfunction or defective seal of boom control valve (suction valve) The suction valve of the boom control valve may have a malfunction or a defective seal. Check it directly. 6 Malfunction or defective seal of centralized safety- suction valve The centralized safety-suction valve may have a malfunction or a defec- tive seal. Check it directly. (A trouble of the centralized safety-suction valve have bad effects on the arm and bucket.) 7 Malfunction of boom cylin- der (lock valve) The lock valve of the boom cylinder may have a malfunction. Check it directly.
8 Malfunction of boom cylin- der (cylinder unit) aPrepare with engine stopped, then run engine at high idling and carry out troubleshooting. Boom cylinder Leakage from cylinder Relieved in RAISE position 15 cc/min