Komatsu — TROUBLESHOOTING

TROUBLESHOOTING H-18 H-18 Travel speed is low 20-518 PC130-7 (1) Trouble • Travel speed is low. Related information • Carry out the troubleshooting in working mode A. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Malfunction of self-reduc- ing pressure valve aPrepare with engine stopped, then run engine at high idling and carry out troubleshooting. Control levers Control circuit basic pressure All levers in neutral 2.84 – 3.43 MPa {29 – 35 kg/cm2} 2 Malfunction of travel PPC valve aPrepare with engine stopped, then run engine at high idling and carry out troubleshooting.

Travel lever PPC valve output pressure FORWARD or REVERSE position 2.84 – 3.43 MPa {29 – 35 kg/cm2} Difference between right and left of above Max. 0.4 MPa {Max. 4 kg/cm2} 3 Malfunction of main relief valve aPrepare with engine stopped, then run engine at high idling and carry out troubleshooting. Control levers Main relief pressure Relieved in TRAVEL position 36.3 – 39.2 MPa {370 – 400 kg/cm2} If the oil pressure does not become normal after adjustment, the main relief valve may have a malfunction or a defect in it. Check the main relief valve directly. 4 Malfunction of travel control valve (spool) The spool of the travel control valve may have a malfunction. Check it directly.

5 Malfunction of travel control valve (pressure compensa- tion valve) The pressure compensation valve of the travel control valve may have a malfunction. Check it directly. 6 Malfunction of travel control valve (suction valve) The suction valve of the travel control valve may have a malfunction. Check it directly. 7 Defective seal of center swivel joint The seal of the center swivel joint may be defective. Check it directly. 8 Defective travel motor aPrepare with engine stopped, then run engine at high idling and carry out troubleshooting. Travel lever Leakage from travel motor Relieved in TRAVEL position Max. 10 l/min 9 Defective final drive The final drive may have a defect in it.

Check it directly. (It may be checked by abnormal sound, abnormal heating, metal chips in drain oil, etc.)