TROUBLESHOOTING S-4 S-4 Engine stops during operations General causes why engine stops during operations 20-612 PC130-7 (1) Seized parts inside engine nsufficient supply of fuel Overheating a If there is overheating and the engine stops, carry out troubleshooting for overheating. Failure in power train a If the engine stops because of a failure in the power train, carry out troubleshooting for the chassis.
Causes ,nekorB dezies ,notsip gnitcennoc dor ,nekorB dezies tfahsknarc gniraeb Broken dynamic valve system (valve, rocker lever, etc.) Broken, seized gear train Broken pump auxiliary equipment Broken fuel pump drive shaft, key Insufficient fuel in tank Clogged fuel filter, strainer deggolC deef pmup reniarts ,nekorB dezies deef pmup notsip ,deggolC gnikael leuf gnipip Clogged air breather hole in fuel tank evitcefeD noitcejni pmup ,kcar( regnulp )kcuts eruliaF ni rewop niart Questions Check items Confirm recent repair history Degree of use of machine Operated for long period Condition when engine stopped Abnormal noise was heard and engine stopped suddenly Engine overheated and stopped Engine stopped slowly There was hunting and engine stopped Replacement of filters has not been carried out according to Operation Manual Non-specified fuel is being used Fuel level lamp lights up Fuel tank is found to be empty When feed pump is operated, operation is too light or too heavy Mud is stuck to fuel tank cap Engine rotates, but stops when power train is operated When it is attempted to turn by hand using barring tool Does not turn at all s Turns in opposite direction Moves amount of backlash Shaft does not turn Rust and water are found when fuel tank is drained Metal particles are found when oil is drained Remove oil pan and inspect directly Remove head cover and inspect directly When gear train is inspected, it does not turn Troubleshooting Rotates when pump auxiliary equipment is removed When fuel filter, strainer are inspected directly, they are found to be clogged When feed pump strainer is inspected directly, it is found to be clogged Inspect feed pump directly When control rack is pushed, it is found to be heavy, or does not return ssi Remove oil pan and inspect directly Troubleshooting of cha Remove head cover and inspect directly When gear train is inspected, it does not turn Rotates when pump auxiliary equipment is removed When fuel filter, strainer are inspected directly, they are found to be clogged When feed pump strainer is inspected directly, it is found to be clogged Inspect feed pump directly When control rack is pushed, it is found to be heavy, or does not return Remedy Replace Replace Replace Replace Replace Add Clean Clean Replace Replace Correct Clean Replace —