TROUBLESHOOTING S-6 S-6 Engine lacks output (or lacks power) When air cleaner element is inspected directly, it is found to be clogged 20-614 PC130-7 (1) eral causes why engine lacks output Insufficient intake of air Insufficient supply of fuel Improper condition of fuel injection Improper fuel used (if non-specified fuel is used, output drops) Lack of output due to overtaking a If there is overheating and lack of output, carry out troubleshooting for overheating.
Causes deggolC ria renaelc tnemele dezieS ,regrahcobrut ecnerefretni nroW notsip ,gnir rednilyc Clogged fuel filter, strainer Clogged feed pump strainer Clogged injection nozzle, defective spray Seized injection pump plunger Improper valve clearance Defective contact of valve and valve seat Bent fuel lever linkage, defective adjustment Clogged, leaking fuel piping Clogged air breather hole in fuel tank Defective boost compensator diaphragm Defective westgate diaphragm Questions Check items Confirm recent repair history Degree of use of machine Operated for long period Power was lost Suddenly Gradually Engine oil must be added more frequently Replacement of filters has not been carried out according to Operation Manual Non-specified fuel is being used Dust indicator lamp is red Color of exhaust gas Black Blue under light load Noise of interference is heard from around turbocharger Blow-by gas is excessive Engine pickup is poor and combustion is irregular High idling speed under no load is normal, but speed suddenly drops when load is applied When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low There is hunting from engine (rotation is irregular) Clanging sound is heard from around cylinder head High idling speed of engine is low Leakage from fuel piping When turbocharger is rotated by hand, it is found to be heavy When compression pressure is measured, it is found to be low When fuel filter, strainer are inspected directly, they are found to be clogged When feed pump strainer is inspected directly, it is found to be clogged Speed does not change when operation of certain cylinders is stopped When control rack is pushed, it is found to be heavy, or does not return When valve clearance is checked directly, it is found to be outside standard value When lever is placed at FULL position, it does not contact stopper When feed pump is operated, operation is too light or too heavy When fuel tank cap is inspected directly, it is found to be clogged Remedy Clean Replace Replace Clean Clean Correct Replace Adjust Replace Adjust Correct Clean Replace Replace