Komatsu — 20-201--.pdf

TESTING AND ADJUSTING MEASURING SOLENOID VALVE OUTPUT PRESSURE, ADJUSTING PLAY OF WORK EQUIPMENT AND SWING PPC VALVES ADJUSTING PLAY OF WORK EQUIPMENT AND SWING PPC VALVES a If the work equipment and swing levers have large play, adjust them according to the following procedure. 1. Remove the work equipment and swing PPC valve assembly. 2. Remove bellows (1). 4. Run the engine at high idling and measure the oil pressure while the control lever or pedal of the measured circuit is in neutral and while it is oper- ated to the stroke end. a If the PPC valve output pressure is as fol- lows, the solenoid valve is normal. 3.

Loosen locknut (2) and tighten disc (3) until it touches the heads of 4 pistons (4). a Do not move the piston at this time. 4. Fix disc (3) and tighten locknut (2) to the speci- fied torque. 3 Locknut: 69 – 88 Nm {7 – 9 kgm} 5. Install bellows (1). 6. Install the work equipment and swing PPC valve assembly. 5. After finishing measurement, remove the mea- suring instruments and return the removed parts. 20-136 PC130-7 (1) Lever/Pedal Output pressure In neutral 0 MPa {0kg/cm2} Operated to stroke end Almost same as control basic pressure (See standard values table)