Komatsu — 20-201--.pdf

TESTING AND ADJUSTING TESTING PARTS WHICH CAUSE HYDRAULIC DRIFT OF WORK EQUIPMENT TESTING PARTS WHICH CAUSE HYDRAULIC DRIFT OF WORK EQUIPMENT a If the work equipment (cylinder) drifts hydrauli- cally, check to see if the cause is on the cylinder packing side or control valve side or hydraulic drift prevention valve side (if equipped) accord- ing to the following procedure. 1. Testing boom cylinder and bucket cylinder 1) Set the machine in the position of measuring hydraulic drift and stop the engine. a Fill the bucket with a rated load or with dirt and sand. 2) Operate the arm control lever in the IN posi- tion.

If the lowering speed is increased at this time, the cylinder packing is defective. If the lowering speed does not change at this time, the control valve is defective. a Operate the control lever while the start- ing switch is in the ON position. a If the pressure in the accumulator is lost, run the engine for about 10 seconds to heighten the pressure in the accumula- tor. 2) When testing the boom cylinder, set the boom control lever in the RAISE position. When testing the bucket cylinder, set the bucket control lever in the CURL position. If the lowering speed is increased at this time, the cylinder packing is defective.

If the lowering speed does not change at this time, the control valve or hydraulic drift prevention valve (if equipped) is defective. a Operate the control lever while the start- ing switch is in the ON position. a If the pressure in the accumulator is lost, run the engine for about 10 seconds to heighten the pressure in the accumula- tor. [Reference] Reason why the lowering speed is increased by the above operation when the cylinder packing is the cause of the hydraulic drift: 1) If the machine is set in the above position (where the holding pressure is applied to the bottom side), the oil leaks from the bottom side to the head side.

Since the volume on the head side is less than that on the bottom side by the volume of the rod, the pressure in the head side is increased by the oil flowing in from the bottom side. 2) As the pressure in the head side is increased, it is balanced at a certain level (which depends on the leakage), and then the lowering speed is low- ered. 3) If the circuit on the head side is opened to the drain circuit by the above operation of the lever (the bottom side is closed by the check valve at this time), the oil on the head side flows in the drain circuit. As a result, the pressure is unbal- anced and the lowering speed is increased. 2.

Testing arm cylinder 1) Stop the arm cylinder about 100 mm before the IN stroke end and stop the engine. PC130-7 20-137 (1)