TESTING AND ADJUSTING MEASURING OIL LEAKAGE 3. Measuring oil leakage from bucket cylinder 1) Run the engine and raise the engine oil tem- perature to 45 – 55°C, and then move the bucket cylinder to the CURL stroke end and stop the engine. 4. Measuring oil leakage from swing motor 1) Run the engine and raise the engine oil tem- perature to 45 – 55°C. 2) Disconnect drain hose (4) and block the hose side with a plug. a Use the following part to block the hose side. 07376-50522 (Plug No. 05) k Release the residual pressure in the piping on the bucket cylinder head side.
For details, see RELEASING RESID- UAL PRESSURE IN HYDRAULIC CIR- CUIT (Operate the lever in the arm CURL direction only, however). 2) Disconnect hose (3) on the cylinder head side and block the hose side with a plate. k Take care not to disconnect the hose on the cylinder bottom side. a Use the following part to block the hose side. 07376-50422 (Plug No. 04) 3) Turn the swing lock switch ON. 4) Run the engine at high idling and relieve the swing circuit by swinging. a Measure the oil leakage for 1 minute after 30 seconds since relieving is started. a After measuring 1 time, swing 180°, and then measure again. 5) After finishing measurement, return the removed parts.
3) Run the engine at high idling and relieve the bucket circuit by curling the bucket. k Take care not to "dump the bucket". 4) Measure the oil leakage for 1 minute after 30 seconds since relieving is started. 5) After finishing measurement, return the removed parts. 20-140 PC130-7 (1)