. MAINTENANCE SERVICE PROCEDURE 4 - 49 8. Remove f ilter cartridge cap (A) and install to the filt 9. When installing, tighten until the packing surface co ntacts the seal surfac e of t he filter h older, then tighten i t 3/4 of a t urn. If the filter cartridge is ti ghtened too far, the packing will be damaged and this wil l lead to leakage of fuel. I f the filter c artridge is too loo se, fuel will also leak from th e packing, so always tighten the c orrect amount When t ightening with a filter wrench, be extremel y careful not to dent or damage th e filter. 10. Chec k th at the drain pl ug at the bottom of the water separator cup is tightened s ecure Tightenin g torque:
0.2 t o 0.45 Nm ( 0.02 to 0.046 kg m, 0.1 to 0.3 lbft) 11. When carrying out stan dard replacement of the fuel filter cartridge (every 1 000 hours), r eplace the cartridge and bleed the air. For detail s, see "REPLACE FUEL FIL TER CARTRIDGE (P AGE 4 -54)". 12. Start the engine, check that there i s no leakage of f uel from the filter seal surfac e or w ater separator mounting surface, t hen run for ap prox. 10 minutes at low idlin