. MAINTENANCE SERVICE PROCEDURE grease 4 - 53 LUBRICATE CENTER DRIVE SHAFT SPLINE (1 place) 1. Using ump, pump fittings marked by the ar rows. 2. After g reasing, wip e off any o ld grease that was pushed CHECK FAN BELT FOR WEA Check the V-belt and when the fo llowin g conditions exist, replace or adjust the V-b When t here is a clearanc e between t he tension p ulley lever an d tip of the adjust ment screw. When t he V-belt makes c ontac t with the bottom o f the groove i n each pulley. When t he V-belt is worn, and it s surface is lower than t he oute r diameter of the p When t he V-belt is crack ed or f laked.
When t he V-belt makes a n abnormal noise A device i s installed to maintain th e tension constan t regardless o f any elongation of the V-belt, so there i s no need to carry ou t adjustmen t until the V -belt i