Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING 4. Check for leakage from fuel line. Check that there is no leakage of fuel or damage to the hoses and tubes. If any problem is found, carry out repairs. 6. Check the undercarriage (track, sprocket, idler, guard) for damage, wear, loose bolts, or leakage of oil from rollers. If any problem is found, repair it. 7. Check for problems in handrails, steps, loose bolts. If any problem is found, repair it. Tighten any loose bolts. 3 - 89 WALK-AROUND CHECK Before starting the engine, walk around the machine and look at the und erside of chassis for anything unusual l ike loose bolts and nuts, leakage o hydraulic system.

f fuel, oil and coolant. Also check the condition of the work equipment and the y, and collection of dust at places that reach high temperature. the Also check for loose wiring, pla y, and collection of dust at places that re ach high temperatur Leakage of oil or fuel, or accum ulation of flammable material around high te mperature parts, such as the engine muffle r or turbocharger, may cause fire. mality is found, repair it or contact your Komatsu distributor. Check carefully, and if any abnor mality is found, repair it or contact your Ko Do not get on or off the machine from the rear.

Using this position is dangero us because it is easy t o slip and you cannot be seen from the operator's compar tment. Always use the handrail and step at t he side when getting o n or off the machine. Perform the following inspection s and cleaning every day before startin g engine for the day' 1. Check for damage, wear, pl ay in work equipment, cylinders, linkag e, hoses Check for cracks, excessive found, repair it. wear, play in wotk equipment, cylinder s, linkage, and hoses . If any abnormalit y is 2. Remove dirt and debris from around the engine, battery, and radiat or.

Check for dirt accumulated a etc.) around the battery, en flammable materials are fou For the method of removing FINS, AFTERCOOLER FIN round the engine and radiator. Also chec k for flammable mate rial (dry leaves, twigs, gine muffler, turbocharger, or other high temperature engine parts. If any dirt or nd, remove them. dirt dirt from the radiator, see "CLEAN AND CHECK RADIATO R FINS, OIL COOLER S (PAGE 4-37)". 3. Check for coolant and oil le akage around the engine Check for oil leakage from th it. e engine and coolant leaks from the coo ling system. If any pr oblem is found, repair 5.

Check for leakage of oil fro m power train case,final drive case,hydr aulic tank,hose,joints Check that there is no oil le Check for leakage of oil fro akage.If any abnormality is found,repair the place where the m the undercover.Check the ground for traces of oil leakage.