. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING after the engine is stopped and may cause serious burns. Wait for the oil the 3 - 96 Parts and oil are at high temperature immediate temperature t o go down before performing this o 1. Open th e engine side co ver on the righ t side of the c hassis. 2. Remove dipstick (G), an d wipe the oil o ff with a cloth . t. 3. Fully ins ert dipstick (G) i nto filler pipe, t hen remove i 4. The oil l evel should be STOPPED side between the H ENGINE If the oil of dipstick (G level is below th e L mark, add oil through oi l filler 5. If the oil is above the H mark, remove drain plug (1 drain val again.
ve (2) to drain th e excess oil, t hen check th e oil l 6. If the oil close the engine side co REMARK When ch ecking the oil lev el after the en gine has bee n operated , wait for at least 15 min utes after stopping the engine be fore checking. gle make it horizontal before checking. the dipstick form the holder to release the air inside the crankcase. If the mac hine is at an an gle make it hor izontal befor e checking When ad ding oil, remove the dipstick for m the holder to release the air inside the crankc The dipst ick is marked wit h the levels for "ENGINE ST OPPED" o n one side and "ENGIN E IDLING" on the other side.
It is also · Check o · Read th possible to check the oil level with the engine idling, but be sure to remember the following points. il when the engine coolant temperature gauge is within the green range. e dipstick on its reverse side marked with "ENGINE IDLING". possible to chec k the oil level w ith the engin e idling, bu t be sure to remember t il when the engi ne coolant tem perature gau ge is within e dipstick on its reverse side m arked with "E NGINE