. OPERATION OPERATION OPERATION OPERATION Ambient temperature Pre-heat time 0 ° C to -20 ° C 20 to 40 seconds -20 ° C or less 40 seconds 6. When the engine starts, release the key in starting switch (2). The key will return automatically to the ON position (B). REMARK Immediately after starting the engine, run at idle. While running the engine, release the decelerator pedal and do not operate the work equipment. Guideline for idle time Cold weather: At least 15 seconds 1st start after changing engine oil or engine oil filter: 20 seconds 3 - 113 3. Check that engine panel lights up. If the engin e pre-heating pilot lamp does no t light, go to ste p 5. pre-heating pilot n th 4.
Keep in thi s condition until engine pre-heating pilot lamp (3) g is completed after approx. 12 seconds, and the out.) re-heating pilot lamp (3) goes out. (Pre-heatin complete lamp goes out.) and the 5. When preheatin g pilot la mp (3) g oes off, tur n the key of ignition switch (2) t o the START positio n (C) to crank the engine. The ti me t hat preheatin g pilot lam p ( stays on changes shown the ble below