. OPERATION OPERATION rotation stabilizes, set fuel control dial low idle (MIN) position, then perform the performed. Turbo protect function The turbo protect function is a function to protect the turbocharger by keeping the engine speed at less than 1000 rpm immediately after the engine is started. Coolant temperature Turbo protect time (sec.) Above 10 ° C (50 ° F) 0 In cold weather, the turbo protect function is actuated, so the engine speed is kept at 1000 rpm or below for several seconds. After that, it becomes the speed set by the position of the fuel control dial.
When the turbo protect function is actuated, the engine speed is held at less than 1000 rpm, regardless of the position of the fuel control dial. 10 to -10 ° C (50 to 14 ° F) Change 0 to 25 below -10 ° C (14 ° F) 25 3 - 114 7. Whe ngine ming-up (1) to REMARK Regardless o f the a mbie nt temperature , if the ke y in st arting switch (2) is turned from the OF F position to t he left, engin e pre-heating pilot lamp ( pre-heating wil start.
ontinue tarting switc h is bein g hel d to th e left.) For d etails of pre-heating times, see th e table i n step Durin lamp (3 Pre-heating i s completed within 45 sec If the engine does not st art after pre-heating, w ait for 2 minutes, then repeat startin g procedure from ste The a ctuatio n time for th e turbo protect function and th e relationship w ith the engine coolant temperature are as show n below . If the fuel control dial is o perated within the time shown below, the engine speed will not c hange.