Komatsu — STARTING ENGINE

. OPERATION OPERATION 11. When the engine rotation stabilizes, set fuel control dial (1) to low idle (MIN) position, the warming-up operation.

REMARK Main causes Disconnected oil pressure switch Failure in starter motor Failure in starter motor relay Does not reach specified oil pressure in 60 seconds 3 - 118 then perform Regardl ess of the ambien t temperature, if the key in starting switch (2 ) is turned fro m the OFF position to the left, engine p re-heating pilot l amp (3) w e left.) re-heating will switch is being hel d to th For deta ils of pre-heating times, se e the t able in step During t peration, engin perform Pre-hea ting is completed within 45 If the en gine does not sta rt after pre -heati ng and prelube, wait f or 2 mi nutes, then r epeat starting procedure f rom step 2.

If it is left for more t han 60 seconds i n same condition as step 5, s peed range d ispla y (4) will return to the c ondition in step 3 As show ormal, adjustment turn prelube OFF, it is p ossibl e to start t he engine. In emergencies, see th e method of use for the adjustme nt mode, move th e machine to a s afe place, then c ontact your Komatsu distributor. how tha Problem Speed range display Engine does not start PE (Flashes) After the prelube operation, it returns again to the Prelube needed position Po (Flashes)