. OPERATION OPERATION to the the "PULL OUT" (F)Front of the machine 3. Move the ripper up or down to set to the desired shank position. REMARK Align mark of ripper (A) with top surface of holder (B). (C) (D) (E) Depth Max. Depth intermediate Depth min. 4. Operate the pin puller control switch to insert the mounting pin. If the pin does not match the position of the hole in the shank, set the pin puller control switch to the "PUSH IN" position (2) and slowly move the ripper up or down. (F)Front of the machine REMARK When raising the pin position to increase the digging depth, use a long protector to prevent wear of the shank.
3 - 150 METHOD OF OPERATING PIN PULLER (Machines e quipped with g iant-shank ripper) 1. Stop the safe place and lower ground. 2. Operate pin puller switch to position (1) and r emov e the mounting pin the shank