Komatsu — TIPS FOR LONGER UNDERCARRIAGE LIFE

. OPERATION OPERATION TIPS FOR LONGER UNDERCARRIAGE LIFE Undercarriage life greatly varies depending on operation method, inspection and maintenance. For most efficient operation, keep the following point in mind. clearance (A) shown in the (0.8 to 1.2 in) at this point. For In clay or sandy areas, inspection and adjustment 3 - 159 OPERATION METHOD uits the type of soil to be encountered in service. r when selecting track shoes. Select the track shoe that best s Consult your Komatsu distributo Do not allow shoe slipage to occu r during operation. If slipage occurs, reduce load to the b lade until slipping stops.

Avoid sudden starts, acceleratio n or stops, unnecessary high speeds and sharp turns. careful not to allow the Always operate machine in a str aight line whenever possible. When making turns, be machine to stay to one side, so operation in both turning directions can be done properly. Make turns with the and obstacles to prevent machine from riding over them while operating. parallel to the inclination of the slope. Also when stopping the ne should face the top of the left or right during digging dig with the incline. Move the d start to dig again. rry out work that exceeds its ludes cases where the idler or d when the machine meets f the machine during dozing or largest possible radius.

Prior to operation, clear boulders and obstacles to prevent machine from riding over the On a slope, operate the machine slope. Do not operate across the machine on a slope, the machi slope. When ground inclines to the operations, do not continue to machine back to level ground an Do not force the machine to ca working capability. Such work inc sprocket come off the groun obstacles that resist the power o ripping operations. INSPECTION AND ADJUSTING Properly adjust track tension. Tension should be measured a diagram - usually 20 to 30 mm ( rocky terrain, tighten tracks slig slightly loosen them. (For procedures, refer to "CHECK AN (PAGE 4-30)"). Check idler rollers for oil leakage nuts.

If any trouble is detected, r INSPECTION AND REPAIR pair will reduce repair costs. Frequent inspection and prompt re The following items for inspection w ill serve as a guide to maintenance service of each und ercarriage part. Perform periodical inspection and contact th limits and reversing limits. e Komatsu distributor in your area when machine has approached repairable limits