. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING (A) (B) When removing, disconnect the cable from the ground terminal first. When installing, connect the cable to the positive(+) terminal first. 3 - 177 It is dan gerous to charge a battery whe n mounted on a machine. Make sure th at it is dismounted before charg ing. y, stop the engine and turn the When c hecking or handling the batter starting The bat switch key to the OFF position tery generates hydrogen gas, s . o there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause s parks. Battery electrolyte is dilute sulfuric aci d, and it will attack your clothes and ski n.
If it gets on your clothes or o n your skin, immediately wash it off with a large amount of water. If it ge ts in your eyes, wash it out with fresh w ater and consult a doctor. handling batteries, always wear safety glasses and rubber When gloves. When r emoving the battery, first disconnect the cable from the ground (normal ly the negative (-) terminal). Wh en installing, install the positive (+) term inal first. If a tool touches the positive terminal a nd the chassis, there is danger that it w ill cause a spark, so be extreme ly careful. If the te rminals are loose, there is dange r that the defective contact may generat e sparks that will cause an expl osion.
When r emoving or installing the termin als, check which is the positive (+) term inal and which is the negative ( -) terminal. REMOVAL AND INSTALLATION OF BATTERY ve the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remo ve the ground cable (normally connected to th e negative ( If any t ool touches between the po sitive terminal and the chassis , there is a haza rd of spark s being generated. When installing the battery, conne ct the ground cable last. it with battery hold-down. ry terminal: 9.8 to 14.7 Nm (1 to 1.5 kgm, 7.2 to 10.8 lbft) When replacing the battery, secure it with battery hold-down.
Tighte ning torque:Tightening batte ry terminal: 9.8 to 14.7 Nm (1 t o 1.5 k gm, 7.2 t