. OPERATION TROUBLESHOOTING 3 - 178 REMOVAL, INSTALLATION O F BATTERY CABLE battery, remove the ground cable 1. Open battery cover (1). 2. Before removing the (normally connected to touches between the po danger of sparks being terminal and remove the 3. When installing the batt Insert the hole of the term Tightening torque: 9.8 to 4. Close battery cover (1). the negative (-) terminal). If a sitive terminal and the chassis, ny t ther ool e is generated. Loosen the nut of the wires from the battery. ery, connect the ground cable last. 3. When installing the batt ery, connect the ground cable last. inal on the battery and tighten the n ut. 19.6 Nm (1 to 2 kgm, 7.2 to 1 4.5 l bft) 4.
Close battery cover (1). PRECAUTIONS WHEN C HARGING BATTERY When the charging the batte ry, if the battery is mistakenly h andled, there is danger of explos ion. Follow the precautions in "IF BATTERY IS DISCHARGE D (PAGE 3-177)" and the instructions given in the charger manual , and always do as follows. Set the voltage of the char ger to match the voltage of the battery to be charged. If the corre ct voltage is not selected, the charger may overheat and cause an explosion. charger clip of the charger to the Connect the positive (+) the positive (+) terminal of the battery, then connect the negative (-) charger clip of the charg the battery.
Be sure to attach Set the charging current t o 1/10 of the value of the rated battery capacity; when carrying out rapid charging, set it to less than the rated b attery capacity. If the charger current is to o high, the electrolyte will leak o r dr y up , and t his may cause the battery to catch fire and explode. If the battery electrolyte i s frozen, do not charge the battery or start the engine with a different power source. s will ignite the battery electrolyte and cause the battery to explode.
atter There is a danger that thi s will ignite the battery electrolyte and cause the battery to exp Do not use or charge the battery if the battery electrolyte lev el is below the LOWER LEV EL line. This may cause an explosion. Check the b attery electrolyte level periodically an d add distilled water to br ing the electrolyte leve to the UPPER LEVEL lin e.