. OPERATION TROUBLESHOOTING STARTING THE ENGINE WARNING 3 - 180 CONNECTING THE BOOSTER CABLES e and problem machine in the OFF position. rder of the numbers marked in the diagram. positive (+) terminal ster cable (A) to the normal machine. negative (-) terminal isolator switch, turn machine to the ON r cable (B) to engine Keep th e starting switch of the normal machin e and problem machine in th e OFF po sition. Connec t the boost er cable as follows, in the o rder of the numbers marked in the dia 1. 2. 3. 4. 5. 1. Connect the cl ip of booster cable (A) to the of b attery (C) on the problem machine. 2. Connect the c lip at the other end of boo positive (+) ter minal of battery (D) on the 3.
Connect the cl ip of booster cable (B) to the of b attery (D) on the normal machine. 4. If th e machine is equipped with a battery the battery iso lator switch on the problem position. 5. Connect the cl ip at the other end of booste bloc k (E) on th e problem machine. Always c heck that th e work equipment lock lever a nd Parking brake lever is set to th e LOCK p osition, regardless o f whether the machine is working normally or has failed. Check also that all the control levers are in the HO LD or N EUTRAL position. 1. Mak e sure the clips are firmly connected to the battery terminals. un it at high idle speed. 2. Star t engine o f the normal machine and r 3.
Tur n the starti ng switch of the problem m achine to the START position and star t the e ngine. If th e engine d oesn't start at first, try agai n after 2 minutes or so. DISCONNECTING THE BOOSTER CABLES After th e engine ha s started, disconnect the bo oster cables in the reverse of the order in whic h the y were connected. 1. Remove the clip of booster cable (B) from the problem machine. 2. Remove the clip of booster cable (B) fr terminal of battery (D) on the normal mac 3. Remove the clip of booster cable (A) fr terminal of battery (D) on the normal mac 4. Remove the clip of booster cable (A) fr terminal of battery (C) on the problem ma 1.
Remove the cl ip of booster cable (B) from engine block (E) on om the negative (-) hine. om the positive (+) hine. om the positive (+) chine. the problem m achine. lip of booster cable (B) fr 2. Remove the c terminal of bat tery (D) on the normal mac 3. Remove the c lip of booster cable (A) fr terminal of bat tery (D) on the normal mac 4. Remove the c lip of booster cable (A) fr terminal of bat tery (C) on the problem ma