Komatsu — HANDLING HYDRAULIC RELATED EQUIPMENT

. MAINTENANCE OUTLINES OF SERVICE 4 - 9 FILTERS Filters are extremely important safety parts. They important equipment and causing problems. Replace all filters periodically. For details, see the However, when working in severe conditions, repla (sulfur content) being used. prevent impurities in the fuel and air circuits from entering Operation and Maintenance Manual. Replace all filters periodically. For details, see the However, when working in severe conditions, repla ce the filters at shorter intervals according to the oil and fuel (sulfur content) being used. e them again. Always replace with new filters.

Never try to clean the filters (cartridge type) and us When replacing oil filters, check if any metal particle s are attached to the old filter. If any metal particles are found, contact your Komatsu distributor. hey are to be used. recommended. Do not open packs of spare filters until just before t Us e of Komatsu genuine filter elements is strongly OUTLINE OF ELECTRIC SYSTEM It is extremely dangerous if the electrical equipmen t becomes wet or the covering of the wiring is damaged. This will cause an electrical short circuit and may lead t o malfunction of the machine. Do not wash the inside of the operator's cab with water. When washing the m components.

achine, be careful not to let water get into the electrical Service relating to the electric system is checking f an belt tension, checking damage or wear to the fan belt and checking battery fluid level. ose specified by Komatsu. Never install any electric components other than th External electro-magnetic interference may cause malfunction of the control system controller, before installing a radio receiver or other wireless equipment, conta ct your Komatsu distributor. electric system to prevent corrosion. he special power source connector. se, starting switch, or battery relay.

When working on the seashore, carefully clean the When installing electrical equipment, connect it to t Do not connect the optional power source to the fu HANDLING HYDRAULIC RELATED EQUIPM ENT During operations and after completion of operatio ns, the hydraulic equipment is at a high temperature. During operations, it is also under high pressure, so when equipment, be careful of the following points. Stop the machine on flat ground, lower the wo operation so that there is no pressure on the cyl Always stop the engine.

Immediately after stopping operations, the hyd pressure, so wait for the oil temperature to go d Even after the temperature has gone down, s loosening plugs, bolts, or hose connections, do release the internal pressure before removing. When carrying out inspection and maintenance tank to remove the internal pressure. Inspection and maintenance include checking the and replacement of hydraulic oil. operations, it is also under high pressure, so when carrying out inspection and maintenance of hydraulic related equipment, be careful of the following points. Stop the machine on flat ground, lower the wo rk equipment completely to the ground, and carry out the inder circuits.

raulic oil and lubricating oil is at high temperature and high own before starting maintenance. ome parts may still be under internal pressure, so when operation so that there is no pressure on the cyl Always stop the engine. mmediately after stopping operations, the hyd I pressure, so wait for the oil temperature to go d Even after the temperature has gone down, s oosening plugs, bolts, or hose connections, do not stand directly in front of the parts, and loosen slowly to to release the internal pressure before removing.

When carrying out inspection and maintenance of the hydraulic circuit, always release the air in the hydraulic hydraulic system for oil level, replacement of filter elements and If high-pressurehoses have been removed, check th at there is no damage to the O-rings. If any damage is found, replace the O-ring. When the hydraulic oil filter elements or strainers ar e cleaned or replaced, or when any hydraulic component has bee ing has been disconnected, bleeding air from the hydraulic