Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 27 The inne r element must not be clean ed and used again. When r eplacing the outer element, repl ace the inner elemen t at the same tim If the inn er element is not installed pro perly and the outer element and cove r are installed, there is d anger that the outer e lement will be da The seal portion on imitation parts la cks precision, and allows th e entry o f dust, which leads to d amage of the engine. Do not use such 7. Remov e the cloth or tape cover installed in Step 3. 8. Check that there is no dirt or oil stuck to the seal portion of the new el ement or cleaned elemen t. Wipe off any dirt or oi l. 9.

Push the outer element in st raight with your hand when dy. when installi If the o to the l inserte ng it to the air cleaner bo uter element is held and r ocked lightly up and dow n and eft and right while pushing it in, the outer element c an be d easily. NOTICE When insert ing the element, if the rubbe r at the tip is swollen or the outer element is n ot pushed in straight, and c over (3) is assembled by fo rce to hook (2), th ere is danger that the hoo k and air cleaner body may be ng. damaged, s o be careful when assembli 10. Install cover (3) as follows. ent. the protruding part of the air osition.

1) Ali 2) Ho cle 3) Wh on as 4) Wh be If it gn cover (3) with the elem ok the tip of hook (2) to aner body and lock it in p en locking hooks (2) in p osition, apply the hooks i n turn opposite sides (top, botto m, left, right) in the same way when tightening bolts. d, check that the clearance en cover (3) is installe tween the air cleaner bod y and cover (3) is not too l arge. is too large, install again .