. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE NOTICE 4 - 26 Never rem ove the inner element (5). It will a llow dirt to enter and cause failure of t Do not use 2. Hold the outer element (4), move it ca refully up and down and to the le while pu ft and right, and rotate the ele ment to the left and right lling it out. moving the outer element, c over the air connector 3. After re inside th dirt or d e air cleaner body with a clea n cloth or tape to prevent ust from entering. 4. Use a br ush or cloth to remove all the d irt stuck to cover (3) and the insid e of air cleaner body (6). 5. Direct d ry compressed air (Max.
0.6 9 MPa (7 kg/cm2, 99.4 PSI)) fro direct th again fr 1) Che inse 2) If th diam repl m the inside of the outer elem ent along its folds. Then e compressed air from the out side along the folds, and om the inside. ck that the inner element is rt it securely. not loose. If it is loose, e yellow piston overlaps the r ed zone (A) on the outer eter immediately after the ou ter element is cleaned, lements. ace both the inner and outer e If small holes or thinner parts are found on the element when it is checked with an electr ic bulb after cleaning and drying, When cleanin g the element, do not hit it or bea Do not use an element whose folds or gasket o 6.
If small holes or thinner parts are fou nd on the element when it is checked with an elect ric bulb a fter cle and dryi ng, replace the element.