Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE in the ADJUSTMENT WARNING WHEN INCREASING TENSION 1. First remove the bolt (1) and then remove the cover (2). NOTICE There is a safety label stuck to the back of cover (2). Be careful not to damage the safety label. 4 - 30 CHECK AND ADJUST TRACK TENSI ON The wear of p ins and bushings on th e undercarriage w ill vary wi th the working conditions an d types of soil. It is thus necessary to continually inspect the track tension so as to maintain the standard tension. bsites where the track Carry out the check and adjustmen t under the same condition s as when operating (on jo th mud).

becomes clo gged with mud, measu re with the track c logged wi INSPECTION hine on level ground (stop with the transmission Stop the mac smission FORWARD without applying the bra ke). Then place a straight b o n the track s hoes between the carri er roller and the idl er as sho in the figure, and measure the clear ance between the bar and t grouser at th e midpoint. If the clear 0 mm (0. to 1.18 in), th e tension is standard. If the track t following ma Grease inside t he adjusting mechanism is under high press ure. Grease coming from plug (4) under pres sure can penetrate t he body ca using injury or death. For this r eason, do not loosen plug (4 ) more than o ne turn.

Do not loosen any part other than plug (4). Furthermore, do not bring your face in front of the grease fitting. If track tension is not relieved by this pr ocedure, contact yo ur Komatsu distributor for repairs. When remo ving cover (2), be careful not to let any dirt ge 2. Pump in pump. grease through the grease fitting (3) with a grea 3. To check machine that the correct tension backwards and forwar has been achieved, move t ds. 4. Check th adjust it a e track tension again, and if the tension is not corre gain.