. MAINTENANCE SERVICE PROCEDURE (For mining specification machine) REMARK the filters cannot be cleaned with air or in water, replace them with new ones. 4 - 43 CLEAN AIR CONDITIONER AIR FILTER (FRESH/RECIRC FILTER Clean the air conditioner a ir filter if it becomes clogged o r if t here is dirt or oil stuck to it. 1. Open inspection cove r (1) and remove fresh air filte r (2 Loosen nut (a), pull handl e (b), and remove the FRESH 2. Remove RECIRC filte r (3) at the rear of the cab. 3. Use compressed air t If there is any oil stuc it in water containing After washing with w again. k to the filter or it is extremely dirty, wash a neutral agent.
ater, dry the filter thoroughly and use it and us I f REPLACE AIR CONDITIO NER BELT 1. Loosen 3 bolts (1) an to the side. 2. Replace the V-belt. When adjusting th directly with a bar. Tighten adjust nut V-belt. The standa to 22 mm (0.71 to 0 (approx. 58.8 N {6 compressor pulley 1. Loosen 3 bolts (1) an d lock nut (2), then move compressor (3) e V-belt, do not push the compressor Use adjust nut (4). (4) and bolts (1), and apply tension to t he rd deflection for the V-belt is approx. 18 .88 in) when the belt is pushe d by thumb kg}) at a point midway between the air and fan pulley. the air