. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUST AIR CONDITIONER CHECK LEVEL OF REFRIGERANT(GAS) WARNING When handling refrigerant gas, always follow local laws and regulations. of the refrigerant circuit. the sight 4 - 44 CHECK TENSION OF COMPR ESSOR BELT If th e belt is loose, it will sli p and the cooling effec t wil l be redu ced. From time to time, pre ss a point midway b etween the altenator drive pulley and compressor pulley wit h your fin ger and ch eck that the ten Wh en the belt is new, the re will be initial elongation, so alwa ys adjust a gain after 2 or 3 For check tension of belt, see "CHECKING (PAGE 4-56)".
T he refrigerant used in th e cooler is colorless and odorless and ot harm the atmosphere, but if the liquid gets into y our eyes or on ands, it may cause loss o f sight or frostbite, so never loosen an If th e level of the refrigera nt (gas) is low, the cooling effect w reduced. Run the engine at high idle, and check t he flow o refrigerant gas (R134a) in the refrigerant circuit through the glas s (2) (inspection wind ow) of the receiver (1) whe n the coo running at high speed. ( A) Correct: No bubble ( B) Low: Bubbles are in (bubbles pass ( C) None:
Colorless, tra REMARK When there are bubble s, the refrigerant gas level is low, so contact your refrigerant dealer to have refrigerant rigerant a dded. If the air conditi oner is run with the refrigerant gas level low, it will cause dam age to the compre New Freon R134a is u sed as the refrigerant. Charge amount of air con ditioner refrigerant (gas): 1