. MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE Center link pin (1 place) (4) Brace screw (2 places) 4 - 54 LUBRICATING 1. Lower the work e quipment to the ground, then stop the engine. 2. Using a grease p ump, pump i n grease through the grease fittings 3. After g reasing, w ipe of f any o ld grease that was pushed out. (1) Blade l ift cylinder support yok e (4 places) (2) Blade l ift cylinder support shaf t (2 places) (Mining sp ecification , if equipped) Centralize d lubricatin (3) Blade-arm ball joi nt (3 places)