Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST CHECKING pressed with a finger force of approx. 6 kg should be approx. 15 mm. 3 4 - 56 Push a point midway between drive pulley (1) and altern ator pulle (2) with a fing er to check the tension . Deflection (A) whe n 1 belt i ADJUSTING 1. Loosen n spots). 2. Turn nut belt tensi when pus uts (2) of adjust bolt (1) and mounting nut (3) (at (4) clockwise, then move alternator (5) to adjust th on so that the deflecti on is approx. 15 mm (0.59 in g. hed with a force of 6 k REMARK When adjusti ng the belt tension, ne ver push the alternat or directl with a bar.

If i t is necessary to push the alternator , insert a piece o wood in-betw een and push it with a bar. 3. Tighten lo osened nuts (2) and ( 3) to secure alternat or (5) (at 3 spots). 4. Check for damage to the pulley s, and wear o f the V- groove a nd V-belt. Be particularly careful to check th at the V-belt is not in contact with the bottom of the V-groo 5. If any bel replace th 6. After repl acing the belt, operate for one hour , then a djust ag or if