. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING 4 - 62 EVERY 500 HOURS Maintenance for every 2 50 hours should be performed at the sam The oil is at high temperatu re after the engine has been operate d, so never change the oil immediatel y after finishing operations. Wait for the oil to cool dow NOTICE If fuel has a high sulphuric content, shorten the replacement int erval of engine oil. For more details, s ee "RECOMMENDED FUEL, COOLANT, AND LUBRICAN T (PAGE 4-12)". Use a venturi compo nent type for the engine oil filter. Refill capacity: 121 lit Prepare a socket wre 1. Open cover under t under drain valve (2 2.
Remove drain plug drain the oil. Take care not to ope pin in the valve is di Tightening torque fo Tightening torque fo 3. Check the drained o foreign material, con 4. Close drain valve (2 5. Use a filter wrench a starting from the fro 6. Clean the filter holde coat the packing sur thinly with grease), t 7. When installing the into contact with the turn. 1. Open cover under t n drain valve (2) so much that th e stopper storted. r drain plug (1): 68.6 ± 9.81 Nm r drain plug (1): 68.6 ± 9.81 Nm (7 ± 1 kgm, 50.6 ± 7.2 lbft) r drain valve (2): 63.7 ± 14.7 Nm (6.5 ± 1. 5 kgm, 47.0 ± il, if there is excessive metal p 10.8 lbft) articles or ug (1). tact your Komatsu distributor. 4.
Close drain valve (2 ) and insert and tighten drain pl 5. Use a filter wrench a nd remove each filter cartridge ( 3) in turn, nt of the machine. 6. Clean the filter holde r, fill the new filter cartridge with engine oil, face and thread with engine oil (or coat it hen install the filter cartridge. filter cartridge, bring the packin g surface filter holder, then tighten a furth er 3/4 to 1