. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE fill with clean fuel. 7. Remove cap (B) after topping off the filter cartridge with fuel. 4 - 66 1. Close the fuel valve (1 ). the fuel pre-filter cartridge to catch the 2. Set a container under oil. 3. Remove transparent c up (3) from the filter (2) and in spect it. If it is broken or damage d, replace it with a new part. 4. Clean transparent cup (3) and remove seal (4). Coa t the new seal with clean fuel or 5. Install transparent cup (3) to the new filter cartridge. Tightening torque for cup:
10 Nm {1.0 kgm, installed to the new filter cartri dge, then NOTICE When filling with fuel, always use fresh fuel and be careful not to let any dirt or d ust get in. Fill with fuel thr ough 8 small holes (A) (dirty side). Cap (B) is to p revent oil containing dirt from getting into the clean side. A lways add the oil with cap (B) installed. 8. Clean the filter hold er, coat the seal surface of , then install the cartridge. the new cartridge thinly with oil 9. When installing, tighte n until the packing surface co ntacts the seal surface of the filt er holder, then tighten it 3/4 of a turn. If the filter cartridge i s tightened too far, the packin ill lead to leakage of fuel.
If g will be damaged and this w fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so rect amount. always tighten the cor