. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 71 3. Using a filter wrenc h, turn f ilter car tridge ( 2) c ounterclockwise to remo NOTICE Do not fill the fuel filter cartridge with fu Remove c ap (A) and in stall the f uel filter 4. Clean th e filter hold er, coat t he pac king surfac e of th e new f ilter cartridg e thinly with oil, then install t he filter cartridge to the f ilter holder. 5. When in stalling, tig hten unt il the p acking surface c ontacts the seal sur of a turn. If the fil will damage d and this will lea d to le akage uel. I f the f ilter cartridg e is too loo se, fuel will als rom acking always tighten to th e correc t amou 6.
After filt er cartridge (2) has been r eplaced wit h a ne w one, bleed air from the cartridge i n reference to "BLEED AIR FR OM FUEL C IRCUIT (PAG E 4-49) ". CHECK FOR LOOSE ROPS MOUNT BO LTS Check for lo ose and da maged bolts. If any loose bolt is found, tighten t o a torque of 1960 to 2450 Nm (200 to 250 kgm, 1446. 6 to 1808.3 lbft). found, replace the bolt with a genuine Komatsu bolt. If any dama ged bolt is found, r eplace the bolt with a ge nuine Komatsu