. MAINTENANCE SERVICE PROCEDURE CHECK, CLEAN FUEL STRAINER 1. Tighten valve (1). 2. Remove cap (2), and wash the strainer and strainer case. The strainer forms one unit with the cap. 3. After checking and cleaning, set the strainer in the case, then tighten cap (2). 4. After installing, open valve (1). REPLACE FUEL MAIN FILTER CARTRIDGE WARNING Prepare a filter wrench and a container to catch the fuel. 1. Set the container under the filter cartridge to catch the drained oil. 2. Close valve (1) of fuel strainer part. 4 - 70 After the engine has been operate d, all parts are at high temperature, so do not replace the filter im mediately.
Wai t for al l parts to cool down before starting the operation. the engine fuel piping system when the engine is running. High pressure is generated inside When replacing the filter, wait fo r at least 30 seconds after stopping the engine to let the interna l pressure go down before replacing the filter. se. leed plug in the fuel filter head. It is still under pressure, so fuel may spurt out. Do not bring any fire or flame clo Be careful when opening the air b leed plug in the fuel filter head. It is still under pressure, so fuel may spurt out NOTICE Genuine Komatsu fuel filter cartr idges use a special filter that has highly efficient filtering ability .
When replacing th e filter cartridge, always use a genuine K omatsu part. The common rail fuel injection sy stem used on this machine consists of more precise parts than the conventional inj ection pump and nozzle. If any part other than a genuine K omatsu filter cartridge is used, dust or dirt may get in and cause problems with the inj ection system. Always avoid using sub stitute parts. When carrying out inspection or maintenance of the fuel system, pay more attention than normal to the entry of dirt. If dirt is stuck to any part, use fuel to was h it off completely.