Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK PIVOT BEARING OIL LEVEL, ADD OIL When removing plug (1), be careful not to let dirt or dust get it. (B): 10 to 30 mm (0.4 to 1.2 in) CHECK OIL LEVEL IN RECOIL SPRING, ASSIST CYLINDER CASE, ADD OIL in. 2. Loosen the plug and confirm that the internal pressure is released. 4 - 81 1. Remov When r e plug (1). emoving plug ( 2. Check t hat the oil is u p to oil level (2 ) in th e diagram. f the oil level is low, a dd oil through the ho le for p lug Remov When r e bolts (1), the emoving the co n remove cove ver, be carefu r (2). l not to Inse rt a sca le and check t hat the oil leve l (a) is 90 to 110 mm to 4.

5 in) fro m the bottom edge of the inspecti on port. If the oil is i nsufficient, ad CHECK ALTERNATOR, STARTING MOTO R The brushe s may be worn or the bearing may h ave run out of gr ease , contact your Komatsu distributor for inspection and repairs . e is started frequently, have this inspection carried out every 1000 hours. If the engin e is started fre quently, have t his ins pectio n carried out