Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT 4 - 85 1. Lower th e work e quipment t o the g round. 2. Operate the parking brake le ver an d the wor k equipment l ock lever to the LOCK p Carry ou t Steps 3 - 5 within When th e engine is s topped, the pr essure in the accumulat or gradually goes down. For this reason , the rel ease can only be carried out immediatel y after the engine is stopped 3. Stop the engine. 4. Turn the starting switch to th e ON position ( 5. then op fully to t the hydr he front, rea aulic circuit. F), blade cont rol lev er and rip per control le ver 6.

Set the work equipment lock lever t o the LOC K position (L), then turn the starting sw itch to the OFF positio n (A).