. MAINTENANCE SERVICE PROCEDURE WARNING the the a to 4 - 86 EVERY 4000 HOU Maintenance for every 250, 500, 1000 and 2000 hou rs service should be ca rried out at th REPLACE ACCUMULATOR (FOR CONTROL CIRCUIT) Replace the accumula tor every 2 years or every 400 0 hours, w hichever co The accumulator is charg ed with high-pressure nitrogen ga s, so mista ken operation may cause an e xplosion, which will lead to serious injury or damage. When handling the accumulator, always do as follows. The pressure in the hy draulic circuit cannot be complete ly removed . When remov ing the hydraul ic equipment, d o not stand in the direction that th the operation.
e oil spurts out when carrying out t he operatio n. In addition , loosen the bolt s slowly when c arrying out e accumulator. me or dispose of it in fire. t or weld it. subject it to any impact. Do not disassemble th Do not bring it near fla Do not make holes in i Do not hit it, roll it, or When disposing of th e accumulator, the gas must be re leased. Ple ase contact y our Komatsu di stributor to hav e this work carried out. If operations are co ntinued after the performance of t ped, it will be impossible to release t accumulator has drop e to remaining pressure in the hydraulic circuit if there should be .
Please ask your Komatsu distributor should be failure on the machine The accumulator is ins talled to the position shown in on the right. CHECK WATER PUMP Check for oil and coola nt leakage, or clogging of the drain hole . If any abnormality is foun d, contact your Komatsu distributor for disassem bly, repair, or replacement.