65 OTHER SERVICING Cleaning the Track Frame Slide Pipes When the slide pipes of the track frame are clogged or adhered with soil or sand, clean the slide pipes in the following manner according to need. 3 WARNING To avoid the personal injury or death: Place the machine on even ground when cleaning the track frame slide pipes. IMPORTANT: Do not operate the engine without coolant. To fi ll the radiator system use fresh water and anti-freeze fl uid. When the anti-freeze is mixed with water, the anti-freeze mixing ratio must be less than 50%. Tighten the radiator cap properly. If the cap is loosely or not properly fi tted, overheating of the engine can result due to coolant fl uid loss. 1.
First lift the machine off the ground using the dozer blade and boom functions. 2. Switch the track width change / dozer select lever to the “Track width change” position. 3. Push the control lever forward, and expand the track width to 49 in. (1240 mm). 4. Remove soil and sand adhered to the slide pipes, then put grease evenly around the pipes. Make sure all 4 slide pipes are greased. 5. Retract and expand the track width repeatedly for a few times by moving the control lever, so that the grease is spread adequately. 6. Switch the track width change / dozer select lever to the “Dozer” position. 7. Place the machine down on the ground carefully by moving the dozer blade and the boom.
(1) Track frame slide pipes Coolant volumes approx. 0.71 US gal (2.7 L) (Reserve tank: approx. 0.16 US gal (0.6 L)