Kubota — Adjustment of Tracks

66 OTHER ADJUSTMENTS AND REPLACEMENTS PURGING OF THE FUEL SYSTEM ADJUSTMENT OF TRACKS 1. Fill up the excavator with fuel. 2. Turn the starter key to the “RUN” position. 3. The air in the fuel system will automatically be purged within one minute. To loosen the tracks, follow the following procedure: 3 CAUTION To avoid personal injury: Do not loosen the grease nipple completely or too quickly. Otherwise grease under high pressure in the tension cylinder could squirt out. Do not crawl under the excavator. 1. Using a socket wrench, loosen the grease nipple a few turns. 2. When grease oozes out from the thread, rotate the track and loosen the track in the lifted position (see illustration).

(1) Starter key (A) “STOP” (B) “RUN” (C) “START” After adjustment is completed: Using the socket wrench, tighten the grease nipple. Tightening torque must be between 72 to 80 ft·lbs (98 to 108 N·m, 10 to 11 kgf·m). IMPORTANT: If the purging was insuffi cient, the engine dies right after starting. In this case repeat steps 2 to 3 again. IMPORTANT: If the tracks are too tight, wear is increased. If the tracks are too loose, the track pads may collide with the sprocket, wear is increased. The track may dislocate or come off. Clean the track after every use.

Should the track tension be high due to sticking mud, lift the track with the help of the boom, arm and bucket, idle the engine and remove mud from the track by rotating it.