Kubota — Adjustment of Tracks

67 Tension the tracks as specifi ed: 1. Apply grease (2) to the grease nipple (1). (1) Grease nipple (2) Grease gun 2. Tension the track in the lifted position, so that the distance "A" (clearance between the track roller and the inside surface of the track) is 0.4 to 0.6in. (10 to 15mm) (see illustration). In this case, the track seam is positioned on the top center between the idler and the sprocket. 3 DANGER To avoid serious injury or death: Do not work under the machine in this condition. For your safety do not rely on hydraulically supported devices, they may leak down and suddenly drop or be accidentally lowered. (1) Seam (Mark “oo”) (A) 0.4 to 0.6 in. (10 to 15 mm) IMPORTANT:

Make sure that no obstacles, such as stones are caught in the track. Remove such obstacles before adjusting the track tension. Track seam The ends of the rubber track are joined with a seam. When adjusting the tracks, the seam must be positioned on the top center between the idler and the sprocket. If the seam is positioned incorrectly, the tracks will be tensioned to loosely, and a further readjustment will be necessary. Rotate the track after adjustment one to two times to check the tension. Additionally following points are to be observed when adjusting rubber tracks. 1) If the track slackens more than 0.98 in. (25mm), readjust them.

2) Check track tension 30 hours after initial use and readjust if necessary. Check and adjust thereafter every 50 service hours.